Commit c329b6c7 authored by Pavel Semerad's avatar Pavel Semerad
Browse files

battery_low from 2V

parent b6bcda32
*0.4.2 ()
added global setting to disable center/reset value beep
minimum battery voltage set to 2V for those experimenting with 1S cell
*0.4.1 (17 Aug 2011)
......
......@@ -110,7 +110,7 @@ Standard menu:
> press ENTER and set channel value for second position or END
> ... up to eight position
for brake cut-off:
> ser OFF or CUT
> set OFF or CUT
- Key mapping specific for each model:
> choose menu REV and press ENTER-long
> menu REV will blink
......@@ -215,7 +215,7 @@ Global setup menu:
F firmware version (this of course cannot be changed :-)
L backlight time 5s,10s...10m...MAX
A inactivity alarm OFF,1m...10m
LOW POWER! battery low voltage 7.5...10.5V
LOW POWER! battery low voltage 2.0...10.5V
E.POINT maximum allowed endpoint value 100...150%
DANGER - values greater than 120% can damage
your servo or will not be possible
......
CHn, DIG for keys - ability to select 2 values to switch between them
timer
- up/down/lap/lap navigate - buttons LAP START, LAP RESET
- ignore lap button after press for 3 seconds to eliminate double clicks
- lap time - after press show last time for 3s and then current time
- somewhere show list of lap times
- TimerUpReset
- TimerUpStart
- TimerDownReset
- TimerDownStart
- TimerLapReset
- TimerLapInc/LapCountInc
more multi-positions - 2 for 6ch, 4 for 8ch, 4-pos is enought
? digital/custom switches (set when some conditions are satisfied)
? setting fail-safe for 8ch receiver
? not so smooth servo travel
Some suggestions taken from manuals of other radios:
timer - up/down/lap/lap navigate - buttons LAP START, LAP RESET
---
? CH3-8 position settable from menu
programmable mixes
throttle speed 1-3 SPEED 1-100%, trigger points 1-100
......
......@@ -137,7 +137,7 @@ static void gs_battery_low(u8 change) {
lcd_segment(LS_SYM_VOLTS, LS_OFF);
return;
}
if (change) *addr = (u8)menu_change_val(*addr, 60, 105, 2, 0);
if (change) *addr = (u8)menu_change_val(*addr, 20, 105, 2, 0);
lcd_segment(LS_SYM_LOWPWR, LS_ON);
lcd_segment(LS_SYM_DOT, LS_ON);
lcd_segment(LS_SYM_VOLTS, LS_ON);
......
Supports Markdown
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment