ChangeLog 4.49 KB
Newer Older
Pavel Semerad's avatar
Pavel Semerad committed
1
*0.6.2 ()
2
3
    added global option to select between 1 or 2 detents of rotate encoder,
	which must be applied to change value
4
5
    for 4WS/DIG/BRAKE, enable it directly after choosing channel, previously
	it was after leaving menu
Pavel Semerad's avatar
Pavel Semerad committed
6

Pavel Semerad's avatar
Pavel Semerad committed
7
*0.6.1 (18 May 2012)
8
    repaired ABS to use cycle length same as before PPM frame length changes
9
    added extra brake channel for throttle brake side
10
11
    repaired steering/throttle/channel speed to not beeing dependent
	on ppm frame length
12
    added buttons LOCK until ENTER-long to global menu
13
    repaired key setting, buttons long RS and EN were unaccesible
Pavel Semerad's avatar
Pavel Semerad committed
14

Pavel Semerad's avatar
Pavel Semerad committed
15
*0.6.0 (28 Apr 2012)
16
    increased model memories by using FLASH also
17
    added more Multi-Positions
18

Pavel Semerad's avatar
Pavel Semerad committed
19
*0.5.1 (26 Apr 2012)
20
21
    added possibility to connect potentiometer instead of CH3 button

Pavel Semerad's avatar
Pavel Semerad committed
22
*0.5.0 (23 Apr 2012)
23
    global menu was restructuralized
24
25
    added ability to select number of channels (2-MAX_CHANNELS) for each
	model, less channels means less delay
26
    poweron warn when not-centered now has separate global option
27
    added up/down/lap timers with throttle trigger start
28
    added BRK button function to override throttle and apply full brake
29
30
    big internal changes handling different menus, key mapping uses
	2-char option identification instead of various symbols
31
32
    added global option rotate_reverse to switch direction of rotate
	endoder at GT3C
33
34
    added globally settable PPM constant sync/constant frame + selection
	of length
35
    added new menu to directly set channel 3-8 value
36

Pavel Semerad's avatar
Pavel Semerad committed
37
*0.4.2 (13 Apr 2012)
38
    added global setting to disable center/reset value beep
Pavel Semerad's avatar
Pavel Semerad committed
39
    minimum battery voltage set to 2V for those experimenting with 1S cell
40
41
42
43
    PPM signal now uses constant length of SYNC signal to get it to
	receiver as soon as possible, also servo values are calculated
	just before generating servo PPM signals to have lowest
	steering/throttle to PPM signal delay
44
45
    ADC measuring every 1ms, averaging last 4 samples when used,
	globally settable to use last 4/1 values
46
    added poweron beep, can be set ON/OFF in global config
47
48
    at poweron, if steering or throttle are not in center dead zone,
	beep 3 times if poweron beep is allowed
49
50
    inactivity timer compares ADC values with previous ones, so now
	it will activate when radio is not center callibrated also
51
52
    added key function BLS to shutup battery low beeper, by default is
	assigned to END-long
53
    3-pos switch instead of CH3 button now works
54

Pavel Semerad's avatar
Pavel Semerad committed
55
*0.4.1 (17 Aug 2011)
Pavel Semerad's avatar
Pavel Semerad committed
56
57

    minimum battery voltage set to 6V
Pavel Semerad's avatar
Pavel Semerad committed
58
    CH3 key set default to OFF
59
    added DGR key function to reset DIG mix to centre
Pavel Semerad's avatar
Pavel Semerad committed
60
    added posibility to select DIG instead of channel number at MultiPosition
Pavel Semerad's avatar
Pavel Semerad committed
61
    added lap count functions assignable to keys
Pavel Semerad's avatar
Pavel Semerad committed
62

63
*0.4.0 (18 Jul 2011)
64
65
66
67

    use steering trim when dual-ESC steering
    added channel_speed for all channels, throttle channel can be applied only
	for forward side
68
69
70
    repaired setting to default values for functions of config-values mapped
	to trims, this should be done only for non-config values (channel,
	mix)
71

Pavel Semerad's avatar
Pavel Semerad committed
72
*0.3.2 (27 Jun 2011)
Pavel Semerad's avatar
Pavel Semerad committed
73

74
75
    added option throttle brake cut of to be able to drive forward only
	vehicles (boats)
Pavel Semerad's avatar
Pavel Semerad committed
76
    added MultiPosition settable to channel
77

Pavel Semerad's avatar
Pavel Semerad committed
78
*0.3.1 (26 Jun 2011)
79
80
81

    DIG mix can be set to channel 1 to have dual-ESC steering (boat, tank, ...)

Pavel Semerad's avatar
Pavel Semerad committed
82
*0.3.0 (24 Jun 2011)
83
84

    added globally settable key long-press delay
85
    when using trims, longer beep at value reset and short pause ignoring keys
86
87
88
    momentary trims/keys now sets value only when state of buttons changed
	(previously it always forced value to reflect button state), so it is
	possible to map momentary and non-momentary keys to the same
89
	channel/mix value, also value is showed when changed
90
91
92
    added possibility for momentary trims and 2-state keys to return not
	to centre/left, but to previous value which was active before button
	press
93

94
95
96
97
98
*0.2.0 (9 Jun 2011)

    added 4WS mix
    added DIG mix
    added steering speed (Turn, Return)
Pavel Semerad's avatar
Pavel Semerad committed
99
    added inactivity alarm
100
    added function C3R for keys to reset channel3 value to centre
Pavel Semerad's avatar
Pavel Semerad committed
101
    internal changes of trims momentary/opposite_reset
Pavel Semerad's avatar
Pavel Semerad committed
102

103
*0.1.0 (2 Jun 2011)
Pavel Semerad's avatar
Pavel Semerad committed
104
105
106

    added special chars "-1" and "10" to be able to display values -199...1099
    both trims-long now only resets, before there was 1 press of first button
107
    changed EEPROM init to eliminate broken initialization
108
    in menu: use ENTER to switch items and END/ENTER-long to end of edit of item
109
110
    added key mapping to configuration of model and removed coresponding
      global settings (trim_step, autorepeat, ch3_momentary)
Pavel Semerad's avatar
Pavel Semerad committed
111
112
113
114
115
116


*0.0.0 (25 May 2011)

    initial public revision