ChangeLog 3.81 KB
Newer Older
Pavel Semerad's avatar
Pavel Semerad committed
1
*0.5.1 (26 Apr 2012)
2
3
    added possibility to connect potentiometer instead of CH3 button

Pavel Semerad's avatar
Pavel Semerad committed
4
*0.5.0 (23 Apr 2012)
5
    global menu was restructuralized
6
7
    added ability to select number of channels (2-MAX_CHANNELS) for each
	model, less channels means less delay
8
    poweron warn when not-centered now has separate global option
9
    added up/down/lap timers with throttle trigger start
10
    added BRK button function to override throttle and apply full brake
11
12
    big internal changes handling different menus, key mapping uses
	2-char option identification instead of various symbols
13
14
    added global option rotate_reverse to switch direction of rotate
	endoder at GT3C
15
16
    added globally settable PPM constant sync/constant frame + selection
	of length
17
    added new menu to directly set channel 3-8 value
18

Pavel Semerad's avatar
Pavel Semerad committed
19
*0.4.2 (13 Apr 2012)
20
    added global setting to disable center/reset value beep
Pavel Semerad's avatar
Pavel Semerad committed
21
    minimum battery voltage set to 2V for those experimenting with 1S cell
22
23
24
25
    PPM signal now uses constant length of SYNC signal to get it to
	receiver as soon as possible, also servo values are calculated
	just before generating servo PPM signals to have lowest
	steering/throttle to PPM signal delay
26
27
    ADC measuring every 1ms, averaging last 4 samples when used,
	globally settable to use last 4/1 values
28
    added poweron beep, can be set ON/OFF in global config
29
30
    at poweron, if steering or throttle are not in center dead zone,
	beep 3 times if poweron beep is allowed
31
32
    inactivity timer compares ADC values with previous ones, so now
	it will activate when radio is not center callibrated also
33
34
    added key function BLS to shutup battery low beeper, by default is
	assigned to END-long
35
    3-pos switch instead of CH3 button now works
36

Pavel Semerad's avatar
Pavel Semerad committed
37
*0.4.1 (17 Aug 2011)
Pavel Semerad's avatar
Pavel Semerad committed
38
39

    minimum battery voltage set to 6V
Pavel Semerad's avatar
Pavel Semerad committed
40
    CH3 key set default to OFF
41
    added DGR key function to reset DIG mix to centre
Pavel Semerad's avatar
Pavel Semerad committed
42
    added posibility to select DIG instead of channel number at MultiPosition
Pavel Semerad's avatar
Pavel Semerad committed
43
    added lap count functions assignable to keys
Pavel Semerad's avatar
Pavel Semerad committed
44

45
*0.4.0 (18 Jul 2011)
46
47
48
49

    use steering trim when dual-ESC steering
    added channel_speed for all channels, throttle channel can be applied only
	for forward side
50
51
52
    repaired setting to default values for functions of config-values mapped
	to trims, this should be done only for non-config values (channel,
	mix)
53

Pavel Semerad's avatar
Pavel Semerad committed
54
*0.3.2 (27 Jun 2011)
Pavel Semerad's avatar
Pavel Semerad committed
55

56
57
    added option throttle brake cut of to be able to drive forward only
	vehicles (boats)
Pavel Semerad's avatar
Pavel Semerad committed
58
    added MultiPosition settable to channel
59

Pavel Semerad's avatar
Pavel Semerad committed
60
*0.3.1 (26 Jun 2011)
61
62
63

    DIG mix can be set to channel 1 to have dual-ESC steering (boat, tank, ...)

Pavel Semerad's avatar
Pavel Semerad committed
64
*0.3.0 (24 Jun 2011)
65
66

    added globally settable key long-press delay
67
    when using trims, longer beep at value reset and short pause ignoring keys
68
69
70
    momentary trims/keys now sets value only when state of buttons changed
	(previously it always forced value to reflect button state), so it is
	possible to map momentary and non-momentary keys to the same
71
	channel/mix value, also value is showed when changed
72
73
74
    added possibility for momentary trims and 2-state keys to return not
	to centre/left, but to previous value which was active before button
	press
75

76
77
78
79
80
*0.2.0 (9 Jun 2011)

    added 4WS mix
    added DIG mix
    added steering speed (Turn, Return)
Pavel Semerad's avatar
Pavel Semerad committed
81
    added inactivity alarm
82
    added function C3R for keys to reset channel3 value to centre
Pavel Semerad's avatar
Pavel Semerad committed
83
    internal changes of trims momentary/opposite_reset
Pavel Semerad's avatar
Pavel Semerad committed
84

85
*0.1.0 (2 Jun 2011)
Pavel Semerad's avatar
Pavel Semerad committed
86
87
88

    added special chars "-1" and "10" to be able to display values -199...1099
    both trims-long now only resets, before there was 1 press of first button
89
    changed EEPROM init to eliminate broken initialization
90
    in menu: use ENTER to switch items and END/ENTER-long to end of edit of item
91
92
    added key mapping to configuration of model and removed coresponding
      global settings (trim_step, autorepeat, ch3_momentary)
Pavel Semerad's avatar
Pavel Semerad committed
93
94
95
96
97
98


*0.0.0 (25 May 2011)

    initial public revision